If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Corair and BIOS settings?
I have a question regarding settings within my BIOS. Gigabyte GA-8KNXP
revision 2.1 with latest FJ BIOS, Northwood 3.2Ghz. I have 1GB matched pair of 3200XLPT and i have set the timings manually to 2-2-2-5 with voltage @ 2.7v I have overclocked the memory, my FSB was at 210, DDR420, at this overclock PAT is enabled and Dynamic Paging Mode is set to enabled. If i go above this to something like 214FSB i see that PAT gets disabled and so does Dynamic Paging Mode. While i can manually enable PAT by setting FCS (Fast Chip Select) to enabled there is no option to enable Dynamic Paging Mode....only options are Auto and Disabled in the BIOS. Thus my question is this, what is Dynamic Paging Mode?...what effect does it have on system performance?, and is there a way to enable it past 210FSB? |
Thread Tools | |
Display Modes | |
|
|