If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Another little problem with my chaintech board
One thing I've never gotten working thus far is the digidoc LCD display. I
know it's supposed to display my CPU temp and all POST codes, but I can't get anything to show up on it. Since I had the Digidoc software installed I can only guess I used the wrong cable to connect it to the system... But then again, the one I used (flat grey) is the only one that makes sence to me. Anyone else have problems with the Digidoc display? Carlo |
#2
|
|||
|
|||
Carlo, Chaintech has released a new version of Digidoc.
http://www.chaintech.com.tw/tw/downl...v1.03.0001.zip Mabe this might fix it? "Carlo Razzeto" wrote in message ... One thing I've never gotten working thus far is the digidoc LCD display. I know it's supposed to display my CPU temp and all POST codes, but I can't get anything to show up on it. Since I had the Digidoc software installed I can only guess I used the wrong cable to connect it to the system... But then again, the one I used (flat grey) is the only one that makes sence to me. Anyone else have problems with the Digidoc display? Carlo |
#3
|
|||
|
|||
"Ugly Mugly" wrote in message
... Carlo, Chaintech has released a new version of Digidoc. http://www.chaintech.com.tw/tw/downl...v1.03.0001.zip Mabe this might fix it? I think that's what I'm running, but thanks for the link. Carlo |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
This problem has baffled everyone... | Nick G | General | 46 | May 22nd 04 04:01 AM |
Athlon XP on old board is 'unknown CPU type' is this gonna be a problem? | Simon | Overclocking AMD Processors | 2 | January 20th 04 08:05 AM |
Chaintech 9EJS1 boot problem | Muttly | General | 2 | October 21st 03 03:39 PM |
board Chaintech 7ATA0 | Brunobr | General | 0 | September 15th 03 10:12 PM |
Stability problem with Chaintech 7NIF2 MB and Athlon XP 2000/266. Need advice!! | Wuahn | General | 2 | July 22nd 03 01:47 PM |