If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem with Shuttle AN35
Finally got everything running in this comp:
Barton 2500+ Shuttle AN35 Generic 1gb 3200 riva tnt2 120gb maxtor and a 40gb maxtor Here's the problem. after i installed the new motherboard and booted for the first time thatit went into windows 98 fine and said that it was installing all this new stuff. So i said great and when it asked me to restart it did. but now i can get into 98 and everything fine but i cannot see any cd drives so i cannot install the real drivers for the AN35. im stuck at 16 colors and 640 * 480 and no new drivers because i cannot use the cd drives. if i dont have the drivers i cannot use the internet or cd drives which means i can tuse the drives or internet to get the drivers. i tried uninstalling all the old drivers from the old motherboard and when they tried to reinstall i would point them at the cd but it wouldnt accept any of the drivers. i grabbed the bootable drive and brought it into my other computer and transfered the contents of the cd over then put the hdd back into the new computer. I ran the setup but whenever i hit setup it comes up with installing nforce drivers and has a progress bar but when the progress bar finishes the setup closes out. no errors or anything. so im stuck here. nothing else to try other than reinstalling the operating system which is last resort. please help, parents getting a little anxious to have their new computer after the first an35 that came was defective |
#2
|
|||
|
|||
"Chris Sandini" wrote in message ... Finally got everything running in this comp: Barton 2500+ Shuttle AN35 Generic 1gb 3200 riva tnt2 120gb maxtor and a 40gb maxtor Here's the problem. after i installed the new motherboard and booted for the first time thatit went into windows 98 fine and said that it was installing all this new stuff. So i said great and when it asked me to restart it did. but now i can get into 98 and everything fine but i cannot see any cd drives so i cannot install the real drivers for the AN35. im stuck at 16 colors and 640 * 480 and no new drivers because i cannot use the cd drives. if i dont have the drivers i cannot use the internet or cd drives which means i can tuse the drives or internet to get the drivers. i tried uninstalling all the old drivers from the old motherboard and when they tried to reinstall i would point them at the cd but it wouldnt accept any of the drivers. i grabbed the bootable drive and brought it into my other computer and transfered the contents of the cd over then put the hdd back into the new computer. I ran the setup but whenever i hit setup it comes up with installing nforce drivers and has a progress bar but when the progress bar finishes the setup closes out. no errors or anything. so im stuck here. nothing else to try other than reinstalling the operating system which is last resort. please help, parents getting a little anxious to have their new computer after the first an35 that came was defective Wrong newsgroup. This newsgroup is for AMD's 64 bit processors only. Try alt.comp.hardware.overclocking.amd |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shuttle XPC Heat Problem | nikoli | General | 17 | July 6th 04 11:04 PM |
This problem has baffled everyone... | Nick G | General | 46 | May 22nd 04 04:01 AM |
Sound card problem | Phileas | General | 10 | May 9th 04 10:55 PM |
Problem with freezing mouse, Windows Explorer | Jon Davis | General | 3 | April 3rd 04 04:06 AM |
Freezing, lock up, unresponsive problem. | James | General | 5 | September 5th 03 02:54 PM |