|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 15th 03, 10:19 PM
|
|||
|
|||
config a compaq array 3200 in a non compaq pc?
How can I install a Compaq smart array controller 3200 on a non-Compaq
machine? I recently acquired (was exchanged for an old computer) a Compaq smart array controller and some drives. All the installation instructions for it refer to using the Compaq smartstart utility. However this won't work on a non-Compaq machine, and when I power on the PC I get an error msg saying that the array is not configured. What can I do to get it working as the boot array for a W2000 installation? Thanks. 
|
|
#2
August 15th 03, 11:58 PM
|
|||
|
|||
|
"David Bartram" skrev i meddelandet ... How can I install a Compaq smart array controller 3200 on a non-Compaq machine? I recently acquired (was exchanged for an old computer) a Compaq smart array controller and some drives. All the installation instructions for it refer to using the Compaq smartstart utility. However this won't work on a non-Compaq machine, and when I power on the PC I get an error msg saying that the array is not configured. What can I do to get it working as the boot array for a W2000 installation? Thanks. Maybe this will be useful to you: http://h18007.www1.hp.com/support/fi...e/20_1269.html Conny
|
|
#3
August 16th 03, 12:23 AM
|
|||
|
|||
|
You need the Array Configuration Utility (HP download under Proliant
servers) and the Array driver , CPQArray.SYS (download on same page , choose all software and search) , configurable when the NOS is installed . On Fri, 15 Aug 2003 22:19:21 +0100, "David Bartram" wrote: How can I install a Compaq smart array controller 3200 on a non-Compaq machine? I recently acquired (was exchanged for an old computer) a Compaq smart array controller and some drives. All the installation instructions for it refer to using the Compaq smartstart utility. However this won't work on a non-Compaq machine, and when I power on the PC I get an error msg saying that the array is not configured. What can I do to get it working as the boot array for a W2000 installation? Thanks.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RAID Array "Off Line" on P4C800-E Deluxe | macleme | Asus Motherboards | 4 | September 1st 04 07:22 PM |
| Compaq FAQ | HH | Compaq Computers | 0 | July 31st 04 02:23 PM |
| Compaq user diagnostics diskette | bananaboat | Compaq Computers | 3 | April 21st 04 03:05 AM |
| Compaq ready to go | Jazzy Ban | Compaq Computers | 0 | October 14th 03 02:54 PM |
| config a compaq array 3200 in a non compaq pc? | David Bartram | Compaq Computers | 2 | August 16th 03 12:23 AM |
Linear Mode
