If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Boot computer using TV as monitor
Mike,
I only have a TNT2, but my server always boots to TV only - I just think you can't have a VGA monitor plugged in at the same time. Dino "Michael Skuczas" wrote in message ... I have a Visiontek GeForce 3 card that has a svideo out on it. Is there a way I can setup that will let me bootup and use the computer with only a TV? I have Win 98 SE and a 1 GHz Athlon and 384 MB of memory. Mike Skuczas |
#2
|
|||
|
|||
"Ken" wrote in message
.com... I too, have the TNT2 64. It has S-Video and Composite outputs but you can't have your monitor hooked up if you want to use them. Plug the TV in, pull the monitor plug and reboot. I have a linux server with a TNT (1) connected to my TV... works fine. Automatically selects TV mode at boot. /M |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Built my first computer, it will not boot up though? | David Mills | General | 56 | January 20th 05 05:24 AM |
Built my first computer, it will not boot up though? | David Mills | Homebuilt PC's | 43 | January 18th 05 03:02 PM |
Computer won't boot | LoSTMaN | Ati Videocards | 1 | March 1st 04 12:32 AM |
monitor to boot? | Bryan | General | 1 | November 18th 03 08:51 AM |
Silent Computer - Advice | David Taylor | General | 49 | October 7th 03 11:26 AM |