If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
TV TOOL DOES NOT WORK WITH COLOUR CONTROL WITH MX440
Ver 8.0 does not work at all with my MX440, anyone know why ?
|
#2
|
|||
|
|||
Version 8 is very buggy IMO use one of the earlier 7.0 versions.
"amstereofan" wrote in message ... Ver 8.0 does not work at all with my MX440, anyone know why ? |
#3
|
|||
|
|||
| Ver 8.0 does not work at all with my MX440
This sftwre is meant to work on certain ICs, not GPUs. v72 cannot work on my Chrontel CH7008A-T. |
#4
|
|||
|
|||
Version 8 is very buggy IMO use one of the earlier 7.0 versions.
IMO, TVTool has never been suitable for an NView-based card. The author has the program's philosphy grounded heavily in the notion that tv support need to be turned on and off and the nview support seems to be an afterthought addon. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Remote Wonder does not work with ATI TV | [email protected] | Ati Videocards | 1 | February 2nd 05 01:07 AM |
Question Catalyst Drivers and Catalyst Control Center | LouisG | Ati Videocards | 4 | January 23rd 05 09:20 PM |
Last/Fastest cB0 stepped 'gray zone' Celerons work natively on Abit ZM6/BM6? | pgtr | General | 15 | July 9th 04 07:29 PM |
DELL upgrade with Kingston Value RAM - will it work properly | stromer | General | 0 | January 31st 04 08:29 AM |
Control Panel failed to load on Radeon 7000 Win98SE | Othello | Ati Videocards | 2 | October 13th 03 08:38 PM |