If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Unstable memory in Dual channel
I've just installed some Kingston 2x512mb 400DDR memory on my new GA-7N400
PRO. The problem is that the system locks when I put them in Dual Channel slots (1&3) but works fine in 1&2. Have I missed something in the BIOS? I can't see anything and the memory is compatible with the mobo. Thanks David |
#2
|
|||
|
|||
Have you checked the timing on the bios is set to what the mem can
support? Aggressive timing might work in single channel and not dual mode. Also, you might want to raise the memory voltage to +1 or +2 and see if that helps. Finally, i'd run memtestx86 in dual and single mode and see if you get errors - could always bee a bad chip. Z "David" wrote in message .uk... I've just installed some Kingston 2x512mb 400DDR memory on my new GA-7N400 PRO. The problem is that the system locks when I put them in Dual Channel slots (1&3) but works fine in 1&2. Have I missed something in the BIOS? I can't see anything and the memory is compatible with the mobo. Thanks David |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dual Channel memory vs. clock speed? | Key-Bored | Overclocking AMD Processors | 6 | October 20th 04 01:37 PM |
nf7 dual channel memory question? | Christo | Abit Motherboards | 0 | September 14th 04 12:48 PM |
MSI Master2-FAR and Dual 244's dual memory channel questions?!!? | Douglas Crane | AMD x86-64 Processors | 0 | August 27th 04 06:40 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Dual Channel Memory Question | CiRcUiT | Overclocking AMD Processors | 18 | September 19th 03 05:01 PM |