If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Easytune 3 & 4
I have a GA-7vtrxh+ board running xp. on installing easy tune it came up
with a warning that the system fan was running at 0rpm. checked and the fan was working, looking in the Bios it also stated 0 rpm, have tried to contact Gigabyte with no luck. any had this problem please Keith |
#2
|
|||
|
|||
Does the fan in question have 3 or 2 wires? The fan will need 3 wires for
RPM monitoring. cheers "Keith" wrote in message ... I have a GA-7vtrxh+ board running xp. on installing easy tune it came up with a warning that the system fan was running at 0rpm. checked and the fan was working, looking in the Bios it also stated 0 rpm, have tried to contact Gigabyte with no luck. any had this problem please Keith |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NEW EasyTune 4... Ver, B04.040901 | DJ! | Gigabyte Motherboards | 1 | April 24th 04 06:29 PM |
EasyTune & BIOS monitor inconsistences | trimble bracegirdle | Gigabyte Motherboards | 0 | April 7th 04 06:52 PM |
8KNXP and Easytune 4 | Striker | Gigabyte Motherboards | 5 | January 27th 04 10:09 PM |
Can EasyTune 4 unlock a Barton? | Peter Harrington | Overclocking AMD Processors | 10 | December 25th 03 02:17 AM |
EasyTune | red | Overclocking AMD Processors | 4 | October 5th 03 02:01 PM |