|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 27th 04, 05:24 PM
|
|||
|
|||
Extreme Memory Timings
Is the 8KNXP ver 2 better able to support ultra low latency RAM better than
ver 1 of this board? 
|
|
#2
April 27th 04, 06:58 PM
|
|||
|
|||
|
I don't think so but I could easily be wrong. I think the only difference
is the sound chip used. Don "Alphad" wrote in message news:fPvjc.31075$cF6.1389678@attbi_s04... Is the 8KNXP ver 2 better able to support ultra low latency RAM better than ver 1 of this board?
|
|
#3
April 28th 04, 02:43 AM
|
|||
|
|||
|
"Alphad" wrote in message news:fPvjc.31075$cF6.1389678@attbi_s04... Is the 8KNXP ver 2 better able to support ultra low latency RAM better than ver 1 of this board? Has anyone been able to get the board run with Corsair 3200LLPT @ 2-2-2-5 or 2-3-2-6?
|
|
#4
April 28th 04, 02:43 AM
|
|||
|
|||
|
"Alphad" wrote in message news:fPvjc.31075$cF6.1389678@attbi_s04... Is the 8KNXP ver 2 better able to support ultra low latency RAM better than ver 1 of this board? I think support, if any, would come from BIOS revisions.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Memory timings? | Richard Dower | Homebuilt PC's | 0 | June 30th 04 01:28 AM |
| Need advise on memory timings (Barton on Nforce II Ultra400 dual channel) | Nil Einne | Homebuilt PC's | 4 | January 13th 04 04:51 AM |
| memory timings p4p800 | robert | Asus Motherboards | 3 | November 10th 03 05:18 AM |
| What RAm for A7V8X-X? | Devast8or | Asus Motherboards | 9 | August 2nd 03 02:05 PM |
| P4P800dx memory timings | Gustav Medler | Asus Motherboards | 1 | July 12th 03 12:38 AM |
Linear Mode
