If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Somehow I am unable to use IDE 1 on my 8IEXP v2.1 what happened ??
Help is needed if possible. Thanks again. When I put the drive on IDE
1 it does not pick up Windows 2000 to boot only when I put it in IDE 2 or secondary does it work..advise please. |
#2
|
|||
|
|||
Are all the onboard IDE ports enabled in the BIOS?
Is the BIOS configured to Autodetect the drives on IDE 1 or is the drive config manually setup in the BIOS as required? Has it worked on IDE1 before? Is the drive jumpered correctly? Is there another device on IDE1 - If so, is it jumpered correctly? John S. "Andy Louie" wrote in message om... Help is needed if possible. Thanks again. When I put the drive on IDE 1 it does not pick up Windows 2000 to boot only when I put it in IDE 2 or secondary does it work..advise please. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PCI V2.1 and V2.3 for wireless networking adapters | CompetiCad | General | 0 | February 10th 05 02:05 AM |
wireless pci v2.1 card | frederic bricout | General | 0 | November 21st 04 10:37 PM |
"Unable to recover TOC" - when burning audio with Nero | Neil | Cdr | 1 | July 16th 04 11:25 AM |
Unable to create Direct3d device | CW | Overclocking AMD Processors | 3 | November 9th 03 05:09 PM |
HELP! Unable to view files | Mike Richter | Cdr | 1 | August 6th 03 06:33 AM |