![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have five A-Bit IC7-G motherboards, each of which is equipped with 4
SATA ports, 2 are on the Intel ICH5 controller 2 are on a separate SiI 3112 chipset My old raptors: 1- WD740GD-00FL 2- WD740GD-00FL Work fine in this motherboard, on either chipset. The newer ratpor drives (16MB cache) are NOT seen at all. Their model numbers a 1- WD740ADFD-00LR1 2- WD740ADFD-00LR1 The only way I can even get the machine to see them is if I enable the RAID BIOS on the SiI chipset, that is the ONLY way to recognize the drives on the motherboard itself. I plugged in the two 16MB cache drives into a Promise SATA 150 TX2 Plus card, no issues. Perfectly recognized. Does anyone know if WD will / can send a firmware update to fix this issue? Or can anyone recommend anything else? I've tried all of the various BIOS settings imaginable and like I said I have several of these A-Bit IC7-G motherboards and _ALL_ 74GB raptors with 8MB of cache work fine, no issues. Any ideas/recommendations on what to do next? Thanks, Justin. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Years Resolution | measekite | Printers | 20 | January 5th 06 01:40 PM |
Long hard drive access times... | Random Person | General | 13 | August 2nd 05 11:49 PM |