939Dual-Sata & Linux: sensors.conf

I am using Linux kernel 2.6.15 and lm_sensors 2.10.0 on an
Asrock 939Dual-Sata2 with an Opteron 165. I have Cool & Quiet
enabled, plus a kernel patch to allow me to lower the idle
voltage to 1.0V (165 only has 2 C&Q states).

My question is, has anyone done any better calibration of
sensors.conf for this board? Fan speeds, temps, etc. Also,
what exactly do temp #1,#2,#3 represent? My negative voltages
are obviously wrong as well, not to mention the 0V for vid
(using ATI 9200 AGP).

I do have only 120mm case exhaust fan#1 connected to a
motherboard header, and a quiet NMB 80mm fan on the CPU
heatsink. Case is Antec Lanboy.

Here is what I get from sensors -f:

w83627hf-isa-0290
Adapter: ISA adapter
VCore 1: +1.02 V (min = +0.00 V, max = +0.00 V) ALARM
VCore 2: +1.12 V (min = +0.00 V, max = +0.00 V) ALARM
+3.3V: +3.44 V (min = +3.14 V, max = +3.47 V)
+5V: +5.19 V (min = +4.76 V, max = +5.24 V)
+12V: +12.34 V (min = +10.82 V, max = +13.19 V)
-12V: +1.87 V (min = -13.18 V, max = -10.80 V) ALARM
-5V: +2.64 V (min = -5.25 V, max = -4.75 V) ALARM
V5SB: +5.70 V (min = +4.76 V, max = +5.24 V) ALARM
VBat: +2.05 V (min = +2.40 V, max = +3.60 V) ALARM
fan1: 1278 RPM (min = 42187 RPM, div = 8) ALARM
fan2: 0 RPM (min = 2109 RPM, div = 8) ALARM
fan3: 0 RPM (min = 1214 RPM, div = 8) ALARM
temp1: +82 F (high = +48 F, hyst = +97 F) sensor = thermistor
temp2: +78.8 F (high = +176 F, hyst = +167 F) sensor = thermistor
temp3: +74.3 F (high = +176 F, hyst = +167 F) sensor = thermistor
vid: +0.000 V (VRM Version 2.4)
alarms:
beep_enable:
Sound alarm enabled

--------------------
ASrock 939Dual-SATA2 BIOS v1.60
Opteron 165 CCBWE @2.47GHz,1.35V
2x512MB Patriot PDC1G4200ELK
http://pcisys.net/~brihall