If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Continous Beeping on startup
(I think I posted this originally in the wrong area so I am trying
again My flatmate just built a computer. I was helping him since I have built one before. He has a AMD Athalon 64 3700 ClawHammer Core socket 754, two 512 DDR400 PC3200, K8 Triton Gigabyte technology motherboard, nVidia 6600, 300gb Seagate 7200rpm, DVD-R However, when we go to turn it on the monitor light turns green (so it is receiving something) but it is just a blank screen. The computer itself just has long beeps continously. I tried putting a jumper on the CMOS to reset it and when I start it with the jumper there is no beeping and still no picture on the monitor. The trouble shooting in the motherboard book said that continous beeping is DRAM error. I switched out the Memory for my memory (which works) but didn't change anything. Then I unplugged everything besided the mother board, cpu heatsink, system fan and memory and still no change in beeping. Any suggestions? |
#2
|
|||
|
|||
Continous Beeping on startup
"kaiser" wrote in message ups.com... (I think I posted this originally in the wrong area so I am trying again My flatmate just built a computer. I was helping him since I have built one before. He has a AMD Athalon 64 3700 ClawHammer Core socket 754, two 512 DDR400 PC3200, K8 Triton Gigabyte technology motherboard, nVidia 6600, 300gb Seagate 7200rpm, DVD-R However, when we go to turn it on the monitor light turns green (so it is receiving something) but it is just a blank screen. The computer itself just has long beeps continously. I tried putting a jumper on the CMOS to reset it and when I start it with the jumper there is no beeping and still no picture on the monitor. The trouble shooting in the motherboard book said that continous beeping is DRAM error. I switched out the Memory for my memory (which works) but didn't change anything. Then I unplugged everything besided the mother board, cpu heatsink, system fan and memory and still no change in beeping. Any suggestions? does the 6600 have a molex power socket? ... if so is it connected? ... my 6800 emits a constant beep without the molex power cord connected. You could also try removing all the memory, if it's a problem with the mobo not liking the dimms then you should get the beep code to say there's no memory rather than there's a fault with the memory it's found. ---------------------------------------- I am using the free version of SPAMfighter for private users. It has removed 2936 spam emails to date. Paying users do not have this message in their emails. Try www.SPAMfighter.com for free now! |
#3
|
|||
|
|||
Continous Beeping on startup
thanks...it actually turned out that a pin on his processor was bent.
They bent is back and it works fine now. And his VGA card doens't have seperate power supply. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATI Radeon 9200 BIOS and XP Startup Problems w/ HP F50 LCD Panel | Alan Spicer | Ati Videocards | 6 | July 10th 05 03:25 AM |
Replace Motherboard?, Need some advice about beeping problem | Dan Mabbutt | Homebuilt PC's | 6 | July 16th 04 02:41 AM |
P4P800 Deluxe - no POST beep on startup | Keithm | Asus Motherboards | 2 | February 25th 04 11:50 AM |
AIW 9600 Pro - TV freeze in MMC 8.8 | H-man | Ati Videocards | 0 | January 18th 04 10:28 PM |
MMC 8.7 crashes a lot when recording | van | Ati Videocards | 2 | October 24th 03 06:57 AM |