If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dell Nvidia FX5200 w/dual DVI monitors
We have Dell GX270s with their low-profile Nvidia FX5200, which has one
DMS-59 connector. Uses a splitter to drive either 2 VGA or 2 DVI monitors. (Two different splitters.) Windows XP SP2. When we were using the VGA spitter with one CRT and one LCD things were fine. Now we've got some extra LCDs so we swapped some over to the DVI splitter with to LCDs. Problem is that we cannot get any signal to the number 2 monitor. We swap monitors, cables, primary/secondary, etc but nothing is coming through. And this in on both machines that we tried. We updated to the latest Nvidia drivers but no luck. Ideas? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
REQ: Dell branded Windows Media Center Edition 2005.. | allegro | Dell Computers | 0 | March 16th 05 11:45 AM |
pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 02:04 AM |
THREE FLOCKING HOURS ON HOLD !!!!!!! | WSZsr | Dell Computers | 15 | September 20th 04 07:28 PM |
Our Dell experience said never again | Rey Barry | Dell Computers | 50 | February 28th 04 11:44 PM |
Bad news for ATI: Nvidia to 'own' ATI at CeBit - no pixel shader 3.0 support in R420 (long) | NV55 | Nvidia Videocards | 11 | February 24th 04 07:29 AM |