If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Canon AX (Same as HP 5) sheet feeder problem after fitting seperator pad
Hi
As my wife will tell you I'm cheap. I decided to replace the seperator pad in my AX based Canon L6000 myself and I've screwed something up. It was $10 instead of $120 so it seemed worth a try. It now feeds one sheet but only about half way into the printer and then reports a jam. The sheet feeder roller does two turns pushing the paper and all the other rollers seem to be turning OK. Is there some some sort of alignment I'm missing between the rollers so it'll push it a little further to hook up with the front rollers? Or something else I should try? Thanks to anyone who can help me remove the egg from my face Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Canon Canoscan D123OU - Problem - Need help | [email protected] | Scanners | 1 | January 25th 05 09:09 AM |
Help needed with unidentified problem | ^MisterJingo^ | General | 3 | November 23rd 04 05:45 AM |
Mouse Problem | Jeff | Homebuilt PC's | 0 | October 1st 04 06:44 AM |
Problem with Canon N670U | Frank Steinmetzger | Scanners | 0 | January 28th 04 02:33 PM |
help with refresh problem please | Michelle | Ati Videocards | 15 | November 27th 03 03:01 AM |