If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Netgear SC101 activation
Just got my SC1010 up and running and then installed the SmartSync Pro
Software. Cannot find the activation code anywhere.... on the CD it says ' the serial number is located on the product back label' - the software cam in a plain paper sleeve? Anyone? Thanks Clive |
#2
|
|||
|
|||
Netgear SC101 activation
Hi Clive,
i had the same problems. You must type in the Serial-Number from you´re storage. You will find them on the SC101 Package under SN Greets Clive schrieb: Just got my SC1010 up and running and then installed the SmartSync Pro Software. Cannot find the activation code anywhere.... on the CD it says ' the serial number is located on the product back label' - the software cam in a plain paper sleeve? Anyone? Thanks Clive |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Netgear router is CONTANTly needing resetting, any suggestions? | Bonnie Peebles | Homebuilt PC's | 1 | October 26th 05 02:03 AM |
Netgear Network Storage SC101 | Matthias Fuidl | Storage (alternative) | 0 | September 29th 05 01:54 PM |
Re-Burn iso without activation | Stephan | Homebuilt PC's | 0 | July 21st 05 08:41 AM |
Can't reconfigure Netgear router after modem change | Jeff | General | 14 | July 19th 04 11:03 AM |
Any problems with Netgear as a brand ??? | newtothis | Dell Computers | 20 | February 3rd 04 05:17 AM |