|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 27th 05, 10:09 PM
|
|||
|
|||
Latest Driver and Nview
With past drivers it has been possible to run the built in display wizard
and select Single, Dual, Clone or Span screen configuration. The latest driver seems to have the Single screen option removed. So how can you switch between Dual and single screen modes now? Regards Mark 
|
|
#2
March 27th 05, 10:20 PM
|
|||
|
|||
|
This (loosing dual option) happened to me yesterday. It is fixed by turning
the monitors (both) on, and rebooting. I think, both monitors need to be detected at the time of bootup. Hope it helps. GT "Mark" wrote in message ... With past drivers it has been possible to run the built in display wizard and select Single, Dual, Clone or Span screen configuration. The latest driver seems to have the Single screen option removed. So how can you switch between Dual and single screen modes now? Regards Mark
|
|
#3
March 27th 05, 10:23 PM
|
|||
|
|||
|
It's not the dual option I have lost.
It's the option in the display wizard to switch back to a single screen that seems to be missing. Regards "GT-Force" wrote in message . .. This (loosing dual option) happened to me yesterday. It is fixed by turning the monitors (both) on, and rebooting. I think, both monitors need to be detected at the time of bootup. Hope it helps. GT "Mark" wrote in message ... With past drivers it has been possible to run the built in display wizard and select Single, Dual, Clone or Span screen configuration. The latest driver seems to have the Single screen option removed. So how can you switch between Dual and single screen modes now? Regards Mark
|
|
#4
March 28th 05, 12:51 AM
|
|||
|
|||
|
"Mark" wrote in
: With past drivers it has been possible to run the built in display wizard and select Single, Dual, Clone or Span screen configuration. The latest driver seems to have the Single screen option removed. So how can you switch between Dual and single screen modes now? Regards Mark Why can't you manually unattach the monitor not used? Right click it in the display settings window and select unattach.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driver question | heian | Nvidia Videocards | 0 | October 1st 04 09:07 PM |
| Gainward FX 5900 Ultra 256 MB driver - not Golden Sample | Phuc Tup | Nvidia Videocards | 7 | July 13th 04 05:56 PM |
| nvidia nview & driver problems with two graphic adapters | Stephan Heuser | Nvidia Videocards | 1 | February 18th 04 04:04 PM |
| Avoid Reinstalling nVidia Driver | Larry(LJL269) | Nvidia Videocards | 0 | December 2nd 03 12:08 AM |
| nView Driver upgrade problem | derob | Nvidia Videocards | 1 | August 28th 03 04:52 PM |
Linear Mode
