If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Abit KT7a softmenu from 100x10 to 100x7,5 = boot problem
Hi,
In softmenu of BIOS KT7a I changed the CPU operating speed from 100x10 to 100x7.5. But now I can't boot the PC. I even tried to reset the bios with the CCMOS jumper. Can anyone help me? Thanks wim wester the netherlands |
#2
|
|||
|
|||
It may be a totally unrelated problem. It may be bad caps.
Check here. http://www.motherboardrepair.com/ "WJW" wrote in message l... Hi, In softmenu of BIOS KT7a I changed the CPU operating speed from 100x10 to 100x7.5. But now I can't boot the PC. I even tried to reset the bios with the CCMOS jumper. Can anyone help me? Thanks wim wester the netherlands |
#3
|
|||
|
|||
Try holding down the Insert key while powering up...If i recall it reset
bios to safe settings. OZoNE -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =----- |
#4
|
|||
|
|||
another suggestion which may sound stupid but if you haven't already try
switching off the PSU at back taking kettle lead out and plug back and switch back on. On Sun, 23 May 2004 19:12:21 +0200, "WJW" wrote: :Hi, : :In softmenu of BIOS KT7a I changed the CPU operating speed from 100x10 to :100x7.5. But now I can't boot the PC. I even tried to reset the bios with :the CCMOS jumper. :Can anyone help me? : :Thanks : :wim wester :the netherlands : ----- Lee. |
#5
|
|||
|
|||
On Sun, 23 May 2004 19:12:21 +0200, WJW wrote:
In softmenu of BIOS KT7a I changed the CPU operating speed from 100x10 to 100x7.5. But now I can't boot the PC. I even tried to reset the bios with the CCMOS jumper. Can anyone help me? Unplug power cord for 15 seconds, then boot holding Insert Key down. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.htm |
#6
|
|||
|
|||
Lee and Wes,
Fantastic! the power cord was the solution. Tried everything else, removed the battery etc. I'm glad it's working again! Thank you very much! Best regards, Wim Wester The Netherlands "Wes Newell" schreef in bericht newsan.2004.05.24.07.46.45.510976@TAKEOUTverizon .net... On Sun, 23 May 2004 19:12:21 +0200, WJW wrote: In softmenu of BIOS KT7a I changed the CPU operating speed from 100x10 to 100x7.5. But now I can't boot the PC. I even tried to reset the bios with the CCMOS jumper. Can anyone help me? Unplug power cord for 15 seconds, then boot holding Insert Key down. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.htm |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NEED HELP: Abit BP6 & Promise RAID cards boot issue | MPG | General | 5 | October 17th 04 12:37 PM |
Boot problem with Promise SATA Fasttrack S150TX2 Plus | Wizard | General | 0 | September 13th 04 06:54 PM |
Abit IS7-E won't boot in enhanced mode | Ambulater | General | 3 | July 10th 04 04:19 PM |
Fastest processor in an Abit KT7A motherboard | Alun Harford | Overclocking AMD Processors | 3 | April 21st 04 10:30 PM |
Abit KT7A and Athon 2600 XP ? | ExtantOne | Overclocking AMD Processors | 4 | March 3rd 04 11:37 AM |