If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
I'm sure I read that you can't put DVD or CD drivers on IDE 3&4 - you can
put normal (non-RAIDed) hard disks on 3 and 4, but I'm under the impression that it would be much better if they were on IDE 1&2 as they won't use the PCI bus. That's why I went for SATA hard drives and left IDE 1&2 for the CD & DVD - I use IDE 3 with a hard disk that's used for backup. For you, I guess best to put the hard drives on 1 and CD&DVD on 2. Taliska "Timothy Drouillard" wrote in message ... The manual reccomends that the IDE-1 connector be used for your normal HD's (two of them), and IDE-2 connector be used for your CD or DVD drives (again two drives) IDE-3 (two drives) and IDE-4 (another two drives) are used with the GigaRAID controller "pd" wrote in message ... I am about to setup my PC with the 8KNXP. I would like to use IDE 1 for my current hard drive, IDE 2 for my DVD, IDE 3 for my CDRW and IDE 4 for my new hard drive. My manual says the GigaRAID controller has a setting called "Normal". It says all the drive will act as independent drive volumes. Will IDE 3 and or 4 support my DVD and or CDRW?? me/ |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setup of A8N SLI-D | Mr B | Asus Motherboards | 2 | February 2nd 05 06:08 PM |
when is xp activation scan done? at setup? | Sam | Homebuilt PC's | 3 | July 6th 04 12:12 AM |
problems with network setup under win2000 | Kai Lehmann | General | 1 | December 12th 03 12:39 PM |
Newbie purchasing A7N8X setup | Chris R | Asus Motherboards | 7 | November 6th 03 01:21 PM |
XP setup doesn't recognize my hard drive (s) - please help me install XP? | Great Weather | Asus Motherboards | 12 | July 9th 03 03:37 AM |