|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 12th 03, 07:57 AM
|
|||
|
|||
Can a Duron on an nforce2 400 run at 266fsb?
u will have to unlock the cpu multipliers but i dont see why that chip
wont run even a 200mhz fsb with a low enough multiplier. On Sun, 12 Oct 2003 06:41:20 +0100, Asfand Yar Qazi wrote: Hi, Can I set the fsb on an nforce2 400 mobo to 266 (or even 333) if I have a Duron 1.2GHz installed? I'm assuming that since the CPU core isn't being changed, this isn't really 'overclocking', as the memory (333MHz crucial stuff) isn't going over spec, and the CPU can be set close to 1.2GHz with multipliers (I don't wannta overclock until I get the hsf properly set with sandpaper and some thermal paste.) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CompGeeks in the US has the Amptron (made by Biostar M7NCD nForce2 400 Socket A MB w/Sound, LAN $38 new | [email protected] | General | 0 | June 29th 04 07:39 AM |
| Is power for Duron nealry all at 12 volts? | kony | General | 3 | April 7th 04 12:35 AM |
| Duron 1000 with marking 27016 | [email protected] | Overclocking AMD Processors | 1 | September 20th 03 06:13 PM |
| Is Duron 1.3GHz Compatible with KT7 (non Raid) m'board....I'm scared..... | Fig \(Cable\) | Overclocking AMD Processors | 1 | September 12th 03 07:13 PM |
| Duron 650 - unreliability problems | Wayne Marsh | General | 6 | August 15th 03 07:42 AM |
Threaded Mode