If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Signal frequency is out of range - Please change timing signal
Have a new TFT monitor.
When my PC starts up I see a "no timing" window (and the motherboard logo is half off the screen) this followed by a window displaying: ---------------------------------------------- Signal frequency is out of range H37.6kHz V50.00Hz Please change timing signal --------------------------------------------- As soon as windows xp starts this disappears. If I uninstall the graphic drivers this window persists. If I resinstall the drivers then I am back where I started. Any ideas? I tried the monitor auto setup. |
#3
|
|||
|
|||
Shep© wrote:
On 29 Dec 2003 10:51:44 -0800 In this world we created (Zordiac) wrote : Have a new TFT monitor. When my PC starts up I see a "no timing" window (and the motherboard logo is half off the screen) this followed by a window displaying: ---------------------------------------------- Signal frequency is out of range H37.6kHz V50.00Hz Please change timing signal --------------------------------------------- As soon as windows xp starts this disappears. If I uninstall the graphic drivers this window persists. If I resinstall the drivers then I am back where I started. Any ideas? I tried the monitor auto setup. Change the monitor refresh rate to one that it and you like in the control Panel/Displapy options. HTH I highly doubt that what you describe will affect the display properties *before* Windows XP loads. -WD |
#4
|
|||
|
|||
Will Dormann wrote in message ...
Shep© wrote: On 29 Dec 2003 10:51:44 -0800 In this world we created (Zordiac) wrote : Have a new TFT monitor. When my PC starts up I see a "no timing" window (and the motherboard logo is half off the screen) this followed by a window displaying: ---------------------------------------------- Signal frequency is out of range H37.6kHz V50.00Hz Please change timing signal --------------------------------------------- As soon as windows xp starts this disappears. If I uninstall the graphic drivers this window persists. If I resinstall the drivers then I am back where I started. Any ideas? I tried the monitor auto setup. Change the monitor refresh rate to one that it and you like in the control Panel/Displapy options. HTH I highly doubt that what you describe will affect the display properties *before* Windows XP loads. -WD As soon as XP loads H37.6kHz V50.00Hz becomes H64.0kHz V60.0Hz and the warning message is no longer seen. (The monitor is capable of higher rates). I cannot see anywhere that the signal timing can be changed prior to windows xp starting. Maybe this is normal ie you live with this warning but I would not have thought so. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can I "mod" a 2-wire fan so the RPMs can be changed? | Winey | Overclocking | 12 | August 5th 04 07:49 PM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Artic Aluminum or "Phase change" material? | SomeBody | Overclocking AMD Processors | 5 | January 9th 04 03:39 AM |
system hotter than cpu | EzAk | Overclocking | 32 | December 22nd 03 06:38 PM |
system hotter than cpu | EzAk | Overclocking AMD Processors | 24 | December 22nd 03 06:38 PM |