If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
P4C800 Deluxe and Rad 9500 Pro
Not sure if this is in the correct forum as it contains both MB and Graphics
card questions. I've just bought a P4C800 D and was intending to fit my Connect3D Radion 9500 Pro, however on page 2-17 of the motherboard manual it states that "if fitting an Ati 9500 or 9700 Pro series card use only the card version PN xxx-xxxxx-30 or later." Mine (of course) has a PN 109-A05600-00. As I am not intending to OC can anyone tell me what the problem is, or, if they are running a 9500 Pro with an early PN do they have any problems? Tia |
#2
|
|||
|
|||
Alan Tetley wrote:
Not sure if this is in the correct forum as it contains both MB and Graphics card questions. I've just bought a P4C800 D and was intending to fit my Connect3D Radion 9500 Pro, however on page 2-17 of the motherboard manual it states that "if fitting an Ati 9500 or 9700 Pro series card use only the card version PN xxx-xxxxx-30 or later." Mine (of course) has a PN 109-A05600-00. As I am not intending to OC can anyone tell me what the problem is, or, if they are running a 9500 Pro with an early PN do they have any problems? Tia I've got the P4C800-D and a 9700 Pro ending in -11 99% of the time, it should work just fine, even with an overclock to 285FSB. Most people with this combo are running without a hitch, especiaqlly if you're not overclocking. Worse case, RMA the card back to ATI and they'll send you a newer card. -=Chris |
#3
|
|||
|
|||
The problem is the AGP-8X implemention on early Radeons.
Once everything is installed go to the smartgart tab of the display settings and set the AGP rate to 4X. You won't notice the difference in performance. I have a -11 9700Pro in a P4C800 Deluxe and it's fine. "Christopher H. Laco" wrote in message y.com... Alan Tetley wrote: Not sure if this is in the correct forum as it contains both MB and Graphics card questions. I've just bought a P4C800 D and was intending to fit my Connect3D Radion 9500 Pro, however on page 2-17 of the motherboard manual it states that "if fitting an Ati 9500 or 9700 Pro series card use only the card version PN xxx-xxxxx-30 or later." Mine (of course) has a PN 109-A05600-00. As I am not intending to OC can anyone tell me what the problem is, or, if they are running a 9500 Pro with an early PN do they have any problems? Tia I've got the P4C800-D and a 9700 Pro ending in -11 99% of the time, it should work just fine, even with an overclock to 285FSB. Most people with this combo are running without a hitch, especiaqlly if you're not overclocking. Worse case, RMA the card back to ATI and they'll send you a newer card. -=Chris |
Thread Tools | |
Display Modes | |
|
|