A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards » Asus Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Owner of three blown Post Diagnostic Cards requires your help...



 
 
Thread Tools Display Modes
  #1  
Old October 19th 04, 06:07 AM
Electronic Components
external usenet poster
 
Posts: n/a
Default Owner of three blown Post Diagnostic Cards requires your help...

Owner of three blown post diagnostic cards requires your help...
Problem is that China Inc. actually went through the trouble
to grind off the chip part numbers :-(

Though "debug cards" can now be had for as low as $10, there
is the desire to refine one's surfacemount soldering skills
and to replace what looks like 10 cent TTL glue logic.

Here is a picture of the same card I have, but with part numbers:
http://cgi.ebay.com/ws/eBayISAPI.dll...ategory=12 44

All the cards sold now look like they retain their chip part
numbers.

If someone purchased this type of card with chip part numbers,
could you either post or e-mail the numbers on the following
ten chips.

U2 -
U3 - (looks like a 74LS02 in the above picture link)
U4 -
U5 - (looks like it reads 74LS04)
U6 -
U7 -
U8 - (looks like GAL16V8)
U9 - (looks like GAL16V8)
U11 -
U12 - (looks like 74F74)

Even better would be if someone has a schematic diagram or went
through the bother to trace one out. If the GAL16V8 chips are blown
one would be SOL, but there is glue logic between them and the bus.


As they say... Strike three and you're out...
  #2  
Old October 19th 04, 09:49 AM
rstlne
external usenet poster
 
Posts: n/a
Default

Try sci.electronics.repair


  #3  
Old October 19th 04, 12:25 PM
Dr. Harvie Wahl-Banghor
external usenet poster
 
Posts: n/a
Default

I was walking down the street, minding my own business, when on 18
Oct 2004 22:07:25 -0700, (Electronic
Components) screamed from behind the mulberry bush:

Owner of three blown post diagnostic cards requires your help...
Problem is that China Inc. actually went through the trouble
to grind off the chip part numbers :-(

Though "debug cards" can now be had for as low as $10, there
is the desire to refine one's surfacemount soldering skills
and to replace what looks like 10 cent TTL glue logic.

Here is a picture of the same card I have, but with part numbers:
http://cgi.ebay.com/ws/eBayISAPI.dll...ategory=12 44

All the cards sold now look like they retain their chip part
numbers.

If someone purchased this type of card with chip part numbers,
could you either post or e-mail the numbers on the following
ten chips.

U2 -
U3 - (looks like a 74LS02 in the above picture link)
U4 -
U5 - (looks like it reads 74LS04)
U6 -
U7 -
U8 - (looks like GAL16V8)
U9 - (looks like GAL16V8)
U11 -
U12 - (looks like 74F74)

Even better would be if someone has a schematic diagram or went
through the bother to trace one out. If the GAL16V8 chips are blown
one would be SOL, but there is glue logic between them and the bus.


As they say... Strike three and you're out...


Those cards have always been ****, even back in the early 90s. Throw
away the junk you have and don't buy them anymore.


  #4  
Old October 19th 04, 02:33 PM
Fishface
external usenet poster
 
Posts: n/a
Default

Electronic Components wrote:
If someone purchased this type of card with chip part numbers,
could you either post or e-mail the numbers on the following
ten chips.


www.focusmagic.com
Download the trial. Clicking on the image gives you a preview.
Sharpens those babies right up...


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Have three blown POST Diagnostic Cards and require help... Electronic Components General 0 October 19th 04 06:15 AM
Have three blown POST Diagnostic Cards and require help... Electronic Components Homebuilt PC's 0 October 19th 04 06:15 AM
Owner of three blown POST Diagnostic Cards requires your help... Electronic Components Overclocking 1 October 19th 04 04:03 AM
dead motherboard quandry (2xPSU, 2xMB, 2Xvideo cards = zero POST) Johan General 5 August 12th 04 11:31 PM
Diagnostic Post Card Ray Homebuilt PC's 0 June 18th 04 03:00 AM


All times are GMT +1. The time now is 05:10 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.