If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Audigy 2zs and onboard sound
Hi, I just installed a a Creative 2ZS PCI board. Although I like it a lot,
I notice that I no longer can use my front audio panel (pluuged into the Audio out on the motherboard) to listen to headphones. Is this there any way I can disable the Soundblaster card hooked to my speakers when I plug in headphone to the front? |
#2
|
|||
|
|||
Take a look at www.frontx.com - you can have a plug in up front for the
headset (and much more if you want) with a cutoff. When no headset is connected it plays through the speakers normally. When headsets are plugged in, it plays through them and cuts out the desktop speakers (Just the right/left). Set up a profile on the soundcard software for "games" to use only stereo sound (if you have a X.1 speaker system) and you're all set. Fitz |
Thread Tools | |
Display Modes | |
|
|