Terrible experience in updating bios 1008 in P4P800DX: Pl. HELP!!

That does sound like your ROM or circuitry is hosed. Try burning it again
to 1008 or 1007and then LOAD DEFAULTS first and then configure as you like.

Mike
"Dolp" wrote in message
...
I just spent hours in updating the bios in my P4P800DX board..but
failed...and with terrible experience.

a few days ago i flashed successfully under dos from 1006 to 1007, using
afudos.
I could overclock, adjust the setting of ram, performance mode etc.
without
any problem.

tonite i downloaded the 1008 bios, followed the instructions..but
failed...
after i flashed..it seemed ok..then i went to bios..changed the
settings...

but then...after saving & rebooted, it said bios checksum bad..bios
recovery
then the pc kept searching for floppy & cd rom for bios rom.

then i changed back to old bios 1007, but the problem is, i can't make any
adjustment in bios to overclock, the setting of ram, performance mode
everytime i made such change, after saving the bios, the pc showed again:

bios checksum bad...bios recovery

then looked for floppy & cd-rom again!!!!

Pl. help!!

I tried clear the RTC and removed battery, but still the same problem.

Can anyone help!!???