If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP C5100a question
Folks,
Picked up one of these original `photoscanners' at a second-hand store. Found a third party (e-mail me) driver/software package for it, and successfully scanned b/w & color negs and slides. However, in scan print mode, it asks for a `calibration card' before it will proceed. Needless to say, I didn't get this card with the scanner. What is it? Is it common with the HP film scanner line, and where might I get one - or how to make one? Any advice appreciated. Bill www.nyx.net/~wboas |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A question about dual monitors | Woodsy | General | 1 | March 11th 05 06:17 AM |
couple of Dimension XPS Gen4 question | Matt | Dell Computers | 3 | March 4th 05 02:20 AM |
Pentium question | Robert Sligh | Overclocking AMD Processors | 4 | April 27th 04 01:13 PM |
Question - Printing 2-up on 11x17 | Don | Printers | 1 | August 24th 03 04:27 AM |
Home PC DVD burner Question. | Ruben | General Hardware | 2 | August 18th 03 05:29 PM |