|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 17th 03, 11:38 PM
|
|||
|
|||
3 Phase supplies and Compaq cabinets
Hiya all
We are trying to install a 10K series Compaq/Hp cabinet to support an EVA5000 the cab has 2 PDU's is it ok to feed the 2 PDU's from separate phases or will this be a health & safety issue ie the potential difference across the 2 phases could reach 480 volts. any URL's to the info would be appreciated. Regards Trevor 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compaq Proliant 5500 won't power up | Jim Balson | Compaq Computers | 7 | September 19th 03 12:05 AM |
| Compaq Proliant 5500 won't power up | Jim Balson | Compaq Servers | 6 | September 19th 03 12:05 AM |
Threaded Mode