If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help! Flashed Bios now I get an error that my RAID Array hasan error
Hi,
Raid controller enabled in the BIOS? Tony Joe Lopez wrote: I flashed my bios to 1007, everything went fine, system rebooted and started up just fine. I got the startup screen for XP, but then the computer rebooted. When it did, I recieved an error message telling me that the RAID array was offline. I tried Rebuilding array, turning on/off, checking the setting in the bios, and nothing seemed to work. I then re-flashed the bios back to the version on the CD, and once again nothing. The system boots up, and then I get a message telling me that there is an error with the array. When I go into the FastBuild utility I can see the array when I select Define Array, but it reads Off Line. I've flashed plenty of bios'es in the past, but this is my first with an RAID array. I can't get it to rebuild either. Is there a way to bring the array back Online? Is there a Bios setting that I'm missing? Did WinXP do this? If so is there a way for me to fix it? I've checked this group, and notice others had no problems, so I'm not sure what went wrong with my update. Any help or thoughts would be great. Joe |
#2
|
|||
|
|||
Yep, Raid is enabled in BIOS. IDE mode is set to enhanced, and only
SATA is selected not SATA+the other option. This is my first home-built PC using RAID, so I'm a little unsure what offline status is supposed to indicate. I assume it means that a problem was discovered and it shut down the array, but shouldn't there be an easy way to reactivate it? Especially since I'm back to the original BIOS before I tried updating. Oddly enough I have the option to create an additional array, which is pretty strange since I only have 2 disks, and they are both set for the original array, which is still displayed. Tony Hwang wrote in message .ca... Hi, Raid controller enabled in the BIOS? Tony Joe Lopez wrote: SNIP |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
P4P800 acting flakey bios checksum failure | Stacey | General | 6 | March 7th 04 04:35 PM |
A7N8X DX Rev 2.0 Bios 1003 vs 1005 Question | Archer | Overclocking AMD Processors | 9 | July 19th 03 08:55 AM |
MSI KT3 ULTRA bios upgrade... | Jerry McBride | Overclocking AMD Processors | 1 | July 12th 03 04:32 AM |
A7V333-X new BIOS 1004 | Paul | Asus Motherboards | 4 | June 26th 03 12:08 PM |
bios hung while flashing | mdp | General | 1 | June 23rd 03 11:18 AM |