Quadro FX Screen Configuration.....problem

Hi All

I have a Quadro FX 2000 attached to an IBM T221 monitor at 3840x2400
resolution.

You can configure this setup in two different ways using the settings:-

1. 1 Monitor running as 3840 x 2400 @ 12Hz

2. 2 Monitors running as (2x) 1920 x 2400 @ 25Hz and then acting as one
monitor using the Horizontal scan mode provided in the drivers.

Option 2 provides a 'seemless' connection allowing the system to operate
as a single monitor and act at 25 Hz.

The problem I have is this....

In certain applications I can set the application to full screen mode
and obviously within the application then choose to use the application
at 3840 x 2400 mode. However the problem is that then the applcation
seems to force the card into option 1 of the two modes described above
thereby forcing the application back into 12Hz mode.

Can anyone tell me if there's a way to for the drivers to be forced to
stay in option 2 mode and thereby avoid the application forcing the
monitor into 12Hz mode?

Thanks in advance.

Regards

P