If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CD or Gigaraid IDE on GA-8KNXP ???
Can the Gigaraid IDE connectors be used for a CD player or CDRW.
I believe not - didn't work when I put them there and I did read that it wouldn't work somewhere. Taliska "Alan Howard" wrote in message ... GA-8KNXP : Can the Gigaraid IDE connectors be used for a CD player or CDRW? If so can it be set as a boot drive? |
#2
|
|||
|
|||
Not worth a damn. I have 4 cd/DVD's using all my primary IDE's and boot
from the HD's on the raid controller. Works great and they can be set as boot if that is what you want. The raid controller is made for hard drives and works well for that but is very flakey with cd's (some will work but not any of mine) I spent 3 hours with every combo you can imagine before the tec and I just put them (cd/DVD's) on the primary's and voila , all was good with the world. "Alan Howard" wrote in message ... GA-8KNXP : Can the Gigaraid IDE connectors be used for a CD player or CDRW? If so can it be set as a boot drive? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
8KNXP - Corsair Twinx 3700 - Bios F8 | Matt. Davies | Overclocking | 5 | December 16th 03 09:01 AM |
8KNXP slow copying over LAN | Scott | Gigabyte Motherboards | 3 | September 2nd 03 10:54 PM |
8KNXP: where can i find IDE driver? | klausa2 | Gigabyte Motherboards | 3 | August 23rd 03 01:15 AM |
8KNXP ITE suffers BAD performance... | modem | Gigabyte Motherboards | 7 | July 27th 03 09:34 PM |
WARNING - Dual Bios & GIGAraid ITE Problems 8KNXP | Mark Taylor | Gigabyte Motherboards | 4 | July 23rd 03 05:54 AM |