If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
XF86Config changes???
Hi,
i have Redhat8 with LILO as bootloader.I want to install new drivers for my video-card(is Riva TNT2 M64 but linux see it as RIVA TNT2). My driver is "nv" and i change it to "nvidia". In README-NVIDIA.txt it say that i must remove the following lines, from /etc/X11/XF86Config: Load "dri" Load "GLcore" At the end of file there are these lines: Section "DRI" Mode 0666 EndSection Question : I must delete them or not??? Thanks |
#2
|
|||
|
|||
add wrote:
Hi, i have Redhat8 with LILO as bootloader.I want to install new drivers for my video-card(is Riva TNT2 M64 but linux see it as RIVA TNT2). My driver is "nv" and i change it to "nvidia". In README-NVIDIA.txt it say that i must remove the following lines, from /etc/X11/XF86Config: Load "dri" Load "GLcore" At the end of file there are these lines: Section "DRI" Mode 0666 EndSection Question : I must delete them or not??? Thanks No you can leave the:- Section "DRI" Mode 0666 EndSection this is not what the nvidia is on about... you only need to remove the Load "dri" Load "GLcore" if they are present in the:- Section "Module" Load "type1" Load "dbe" Load "freetype" Load "glx" Load "v4l" Load "speedo" Load "extmod" EndSection Part of XF86Config or XF96Config-4 depending which one your system uses by default. HTH -- Mark Twixt hill and high water. N.Wales, UK. Email is spam trap try baskitcaise at gmx dot co dot uk |
#3
|
|||
|
|||
ok,all works fine.
Thanks. |
Thread Tools | |
Display Modes | |
|
|