8KNXP Ultra SCSI RAID-0 Hibernate problem

I do not know if this was always a problem but recently I decided to use the
Hibernate function of Windows XP and found that when booted from my SCSI
Raid-0 drive, I get Stop Error 0x000000D1 associated with SCSIPORT.SYS when
attempting to go to Hibernate mode. On same system, same exact OS but loaded
from IDE drive gives no error.

If one of you have SCSI Raid-0 on your system, can you initiate Hibernate? I
have looked up all info about this but the closest I get is to replace the
Scsiport.sys from system disk, which I did but that does not help. All the
cable termination is correct, using active cable terminator. The drive ID's
are also set properly.

--
Pavel

Just found the culprit....It's Alcohol 120% driver Xmasbus.sys. Others have
similar problem.

--
Pavel


"Pavel" wrote in message
m...
I do not know if this was always a problem but recently I decided to use
the
Hibernate function of Windows XP and found that when booted from my SCSI
Raid-0 drive, I get Stop Error 0x000000D1 associated with SCSIPORT.SYS
when
attempting to go to Hibernate mode. On same system, same exact OS but
loaded
from IDE drive gives no error.

If one of you have SCSI Raid-0 on your system, can you initiate Hibernate?
I
have looked up all info about this but the closest I get is to replace the
Scsiport.sys from system disk, which I did but that does not help. All the
cable termination is correct, using active cable terminator. The drive
ID's
are also set properly.

--
Pavel