If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Flatpanel open missing in control panel
Is there any way to force the flatpanel options to appear in the control
panel (driver 94.24). After a fresh install of windows the flatpanel options appeared the 1st time I opened the control panel but dissapeared the second time (without even a reboot). The monitor is detected as a flat panel by the driver but the "Flat panel" options are missing. Monitor is connected by DVI. Anyway to bring back the missing option? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Control Panel Help | JLC | Ati Videocards | 2 | November 14th 06 04:37 AM |
Catalyst Control Center versus Control Panel? | Don Burnette | Ati Videocards | 7 | January 20th 05 03:23 AM |
Control Center or Control Panel? | mikea | Ati Videocards | 5 | December 4th 04 01:17 PM |
SmartGART Tab is Missing in Original Control Panel | V Green | Ati Videocards | 2 | September 16th 04 06:00 PM |
Control panel for Compaq IJ700 missing | Steve Manos | Printers | 1 | January 28th 04 09:33 PM |