If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DFI AK74-ec motherboard -- lowering bus speed
I read that a solution to the ak74-ec locking up is to lower the bus
speed. Unfortunately, the motherboard manual doesn't mention how to do this. Anyone know how to accomplish this? Much appreciated. |
#2
|
|||
|
|||
DFI AK74-ec motherboard -- lowering bus speed
http://www.dfi.com.tw/Upload/Manual/...2084900502.pdf
bios manual wrote in message oups.com... I read that a solution to the ak74-ec locking up is to lower the bus speed. Unfortunately, the motherboard manual doesn't mention how to do this. Anyone know how to accomplish this? Much appreciated. |
#3
|
|||
|
|||
DFI AK74-ec motherboard -- lowering bus speed
Thanks for your input, JAD. The link you gave me was actually for different motherboard but I did find a manual for the ak74-ec he http://us.dfi.com.tw/Upload/Manual/43840104.PDF Unfortunately, the manual doesn't mention anything about altering the bus speed... JAD wrote: http://www.dfi.com.tw/Upload/Manual/...2084900502.pdf bios manual wrote in message oups.com... I read that a solution to the ak74-ec locking up is to lower the bus speed. Unfortunately, the motherboard manual doesn't mention how to do this. Anyone know how to accomplish this? Much appreciated. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DFI AK74-EC motherboard -- lowering bus speed | [email protected] | AMD Thunderbird Processors | 0 | October 29th 06 01:38 AM |
i'd like to overckloc but i'd need help | Paolo Bresi | Overclocking | 1 | May 20th 06 08:38 PM |
Seagate Barracuda 160 GB IDE becomes corrupted. RMA? | Dan_Musicant | Storage (alternative) | 79 | February 28th 06 08:23 AM |
P2B 266 Asus | Johnathon Aaron Steel | Overclocking | 3 | September 13th 05 07:25 AM |
Can’t get P3 650 MHZ Over 714 Mhz with Easytune4!!! | Phil Weldon | Overclocking | 28 | July 2nd 05 04:36 AM |