If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Compaq sw3322
I have a switch sw3322 during the diagnostic test i have this message
Descriptor Table Memory -- Address line, random data .............. FAILED. !!! !!! -- FAILED Descriptor Table Memory -- Address line, random data -- !!! !!! Reason: Memory test failed. !!! !!! Run number : 1 !!! Failed address : 0x000209C3 !!! Expected data : 0x 46 !!! Actual data : 0x 0 !!! ================================================== ========================== I would like know how i can resolve the problem because this error give me a problem during the start up. Thanks Mauro |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compaq FAQ | HH | Compaq Computers | 0 | October 17th 04 12:49 PM |
Compaq FAQ | HH | Compaq Computers | 0 | September 23rd 04 12:21 PM |
Compaq FAQ | HH | Compaq Computers | 0 | July 31st 04 02:23 PM |
Compaq FAQ | HH | Compaq Computers | 0 | July 3rd 04 04:25 AM |
Compaq ready to go | Jazzy Ban | Compaq Computers | 0 | October 14th 03 02:54 PM |