If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GA-M57SLI-S4 Rev 2.0 front panel sound problems
I have recently upgraded my PC to a GA-M57SLI-S4 Rev. 2.0 mobo. I had
everything working, including the front panel, then I unplugged the microphone and headphone front panel connectors from the motherboard, plugged them in again (wrongly), so had to replug them the correct way and now the Realtek sound management software doesn't show that there are any front connectors active, and the headphone / mic sockets do not work. The sound works from the rear connectors. It is a Realtek ALC888 which is HD Audio but the case front panel connectors are AC97 only. I have followed the directions for providing AC97 compatibility for the ALC888 HD audio in the management software. The front panel box works because I tested it on another motherboard. Any suggestions, help would be gratefully appreciated. The layout from the mobo manual is as follows: 1 MIC 2 GND 3 MIC Power 4 NC 5 Line Out (R) 6 NC 7 NC 8 No pin 9 Line Out (L) 10 NC And the cables for the front panel audio a MIC IN MIC Power Ground Out-L x 2 (one is L-RET) Out-R x2 (one is R-RET) Paul |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
m55plus-s3g front panel sound connectors??? | Strutter1982 | Gigabyte Motherboards | 5 | April 21st 07 07:31 AM |
front panel sound | Randy Davis | Asus Motherboards | 3 | May 8th 06 05:17 AM |
P4R800-VM Front Panel - Sound Issues | Al | Asus Motherboards | 2 | July 26th 04 06:36 PM |
What cases have USB, Sound and 1394 ports on its front panel? | profiled | General | 2 | July 16th 03 01:16 PM |
What cases have USB, sound ports and 1394 on its front panel? | profiled | Homebuilt PC's | 0 | July 16th 03 07:19 AM |