If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
What can be?????
I have had errors in the past like this when the master and Slave settings
are incorrect on the drives. Worth a check...... "theo" wrote in message . .. Into my computer the BX2000 mainboard, upgraded with the F9 biosversion. As harddisk I'm using the Maxtor 6Y200PO, (200GB). I'm running windows xp pro on this. Now I'm facing the problem that windows doesn't start up anymore. The symptones are these: - First the bios detects first en second master and slave disk (these all are present and in the bios is standing to detect them automaticly) - Second the HDD S.M.A.R.T. capability will be enabled. - Third you will see your PCI device listing-list - Fourth is Verifying DMI Pool Data After this line windows has to start up but instead I'm hearing the computer a smalle sound (like the detection of the 1.44mb-disk-station) and on the screen where the line Primairy Master HDD S.M.A.R.T. capability .... enabled was standing is standing now the same line but the 'b' of enabled is missing. Like this: Primairy Master HDD S.M.A.R.T. capability .... ena led. I have three possible solutions for this: 1. my bios or mainboard is damaged I need to buy a new one 2. my harddisk is the problem (don't think so because I have had the same problem with my old harddisk, IBM-dpta-372730 (27GB), inside) 3. or windows is the problem. Anyone any idea????? |
Thread Tools | |
Display Modes | |
|
|