If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Maxtor DiamondMax 10 platters?
Does anyone know how many platters the DiamondMax 10 200GB SATA drive has?
Maxtor does not list it in their data sheet, unlike the datasheets for earlier generation drives. |
#2
|
|||
|
|||
On Fri, 29 Oct 2004 14:19:13 -0400, "James H. Fox"
wrote: Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Maxtor does not list it in their data sheet, unlike the datasheets for earlier generation drives. Current-gen drives have 100GB per platter IIRC, so that's 2 platters... even if they're up to 120GB/platter that's still 2 platters. |
#3
|
|||
|
|||
Does anyone know how many platters the DiamondMax 10 200GB SATA drive has?
Open it and see.. g Regards, Chris |
#4
|
|||
|
|||
Skeleton Man wrote:
Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Open it and see.. g Regards, Chris I am not that desparate (yet). But if someone has bought one, it might give the number of platters on the label. It is possible they use three platters, although two is more likely. |
#5
|
|||
|
|||
"James H. Fox" wrote in message ... Skeleton Man wrote: Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Maxtor's website should list it someplace in their specs. If not, you could always email them. |
#6
|
|||
|
|||
"Noozer" wrote in message news:2ZOgd.65115$%k.63804@pd7tw2no... "James H. Fox" wrote in message ... Skeleton Man wrote: Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Maxtor's website should list it someplace in their specs. If not, you could always email them. I did email Maxtor tech support, and here is their answer: "All DiamondMax 10 drives are based on the company's 100GB-per-platter platform. So there are two platters in your 200-gig DiamondMax 10 drive." |
#7
|
|||
|
|||
"Noozer" wrote in message news:2ZOgd.65115$%k.63804@pd7tw2no... "James H. Fox" wrote in message ... Skeleton Man wrote: Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Maxtor's website should list it someplace in their specs. If not, you could always email them. I did email Maxtor tech support, and here is their answer: "All DiamondMax 10 drives are based on the company's 100GB-per-platter platform. So there are two platters in your 200-gig DiamondMax 10 drive." |
#8
|
|||
|
|||
"James H. Fox" wrote in message ...
"Noozer" wrote in message news:2ZOgd.65115$%k.63804@pd7tw2no... "James H. Fox" wrote in message ... Skeleton Man wrote: Does anyone know how many platters the DiamondMax 10 200GB SATA drive has? Maxtor's website should list it someplace in their specs. If not, you could always email them. I did email Maxtor tech support, and here is their answer: "All DiamondMax 10 drives are based on the company's 100GB-per-platter platform. So there are two platters in your 200-gig DiamondMax 10 drive." Are these blighters noisy? The Diamondmax 9s were terrible |
#9
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Replacing platters in a WD800BB hard drive. | msr | General | 14 | August 11th 04 03:41 PM |
HD failure can I replace platters into a new HD to recover data | Larry Tannahill | General | 3 | September 15th 03 08:20 PM |
Physical repair for IDE harddrive | WDsux | General | 36 | August 29th 03 04:24 AM |