|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 22nd 08, 11:10 AM
posted to comp.sys.hp.hardware,alt.sys.pc-clone.compaq.servers
|
|||
|
|||
Power supply signal cable header for COMPAQ Proliant DL 380
Hi.
I'm trying to substitute the COMPAQ DL380 (G1) Server Mainboard with my VAX 4000 KA54, NVAX 100MHz Mainboard to get rid of the BA42A Case. The mechanical rebuilding is simple. The SCSI devices (4x36GB,Plextor-CDROM und 12/24GB DAT) are identified and operational. Floppy and IDE-CDROM are disconnected. The Power supply power connector is easy to discover. Only the Power supply signal cable (14pin between hot plug power supply bd and system board) is a mystery. That what I've discovered: +3.3VS+ black o o black +3.3VS- +5.1VS+ black o o red +5.0V AUX key x o black +5.1VS- ON_STB black o o black ?? PG black o o black ?? ?? black o o black ?? ?? black o o black ?? S+/S- = Sense. ON_STB = pull to GND for PowerOn. PG = PowerGood. Maybe even this is wrong. Any help/assistance on this subject would be greatly appreciated. -Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compaq Proliant 5500 Power Supply question & spontaneous reboot problem.. | Rick F. | Compaq Servers | 19 | September 2nd 05 10:01 PM |
| ATX Power Supply Header Question | [email protected] | Homebuilt PC's | 3 | December 31st 03 11:34 PM |
| Compaq proliant 1200 power supply pinout. | Jurgen ten Buuren | General | 0 | December 2nd 03 09:07 PM |
| Compaq proliant 1200 power supply pinout. | Jurgen ten Buuren | Homebuilt PC's | 0 | December 2nd 03 09:07 PM |
| Compaq Proliant 1200 Power supply pinout | Jurgen ten Buuren | Compaq Computers | 0 | December 2nd 03 08:42 PM |
Threaded Mode