If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP2000 New Ink Well Assembly Installed
Original Problem: Cyan bongo pad bad - cyan reads empty and printer will not
print.. New ink well assembly installed without a hitch and the printer is working like new. However, the cyan cartridge still reads empty and I know that it is half full. My guess is that the smart chip on the cyan cartridge has recorded the out of ink message from the time the bongo pad originally failed. If this is the case I do not think that there's a way to correct/reset the cyan ink level. Or, is there? Does anyone know if the cartridge will continue to print until it is actually empty despite the erroneous visual cyan indicator? I believe this printer has another way of reading the cartridge ink level by monitoring internal cartridge pressure? Just guessing here...I guess time will tell. If someone knows the mechanism behind this I would like to hear more about this.... Signed just curious. Ciao, Bob |
#2
|
|||
|
|||
Correct on all assumptions. Continue using the cartridge until it runs out
of ink, or until the printer fails again with another problem, then toss it...... "Bob Van der Bloemen" wrote in message . .. Original Problem: Cyan bongo pad bad - cyan reads empty and printer will not print.. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Newly Installed 9600XT!! | Ron | Ati Videocards | 4 | January 31st 04 08:07 PM |
GA8KNXP: installed latest Si3112 driver & now cannot boot from RAID1. | Danny TAY | Gigabyte Motherboards | 9 | January 22nd 04 04:30 AM |
Can Roxio and Nero be installed on the same machine. | Ken Applequist | Cdr | 7 | January 17th 04 12:28 PM |
ATI All In Wonder installed but NO TUNER! | Pim | Ati Videocards | 3 | December 4th 03 02:30 AM |
I`m just seeing negative stuff about 3.9 - Some have installed them successfully and happily?? | Melandre | Ati Videocards | 7 | November 11th 03 06:30 AM |