If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
LC-20 dot-matrix printer
Hello!
Greets to All!I am not sure if this is a proper place to ask about my problem, if it isn't correct me please.I'm writing program(you may call it driver) for printing only one type of invoice, and I'm having problems with text positioning. Recently I was working on driver to label printer where you could set the position of text by passing its coordinates (X,Y in 0,1mm), so no problem. Now dot-matrix printer prints line after line, so I don't have a possibility to set text position directly. I can use only few different types of line spacing (vertical position) and different tabs values for horizontal positioning( on input I get X,Y coord of text in 0.1 mm). I would be very grateful for any suggestions and help!If anyone wrote such a stuff, I would take a few pointers!Thanks for any valuable answers! Best regards! Daniel |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
USB Printer Problems | Kevin Altizer | General | 9 | July 24th 04 04:28 PM |
Serial printer in LAN | Maurizio | General | 1 | June 30th 04 12:59 PM |
Printer partially ejects on cold boot | *Vanguard* | General | 3 | May 15th 04 11:50 PM |
Linux to emulate/act as a printer. | Peteris Krumins | General | 0 | December 26th 03 04:22 AM |
USB or parallel port, which should the printer use? | *Vanguard* | General | 6 | November 29th 03 09:01 PM |