If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Fans the connect to the PS instead of the mobo
Does anyone know where I can get fans that connect to an ATX power
supply instead of the regular fan connectors on the motherboard? Thanks, Harold |
#2
|
|||
|
|||
|
#4
|
|||
|
|||
Should be able to visit any electronics parts store and get a 4-pin
Molex kit, like the one pictured at http://www.kdcomputers.com/eui/prime/profile/677.htm, but I don't remember if you need the male or female kit (got nothing to look at right now). Cut off the old connector and crimp on the pins for the new one and insert into housing. For the 3rd RPM sense lead that goes unused, you could put heatshrink over it or just message the insulation down so the wire end isn't exposed, and use a wire tie to keep it together with the other wires. -- __________________________________________________ Post replies to newsgroup. E-mail not accepted. __________________________________________________ "NOSPAM" wrote in message om... Does anyone know where I can get fans that connect to an ATX power supply instead of the regular fan connectors on the motherboard? Thanks, Harold |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Silent Computer - Advice | David Taylor | General | 49 | October 7th 03 11:26 AM |
REQ: Need help connecting front USB on M7VIG Pro MOBO | [email protected] | General | 6 | September 8th 03 03:26 PM |
Sleeve bearing fans | Adrian | General | 6 | August 2nd 03 01:14 AM |
Power suppply with 12V and mobo without 12V connect - works? | NuQ | General | 7 | July 28th 03 07:57 PM |
New mobo - comp still won't boot | Cyde Weys | General | 5 | July 7th 03 07:49 PM |