A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors » AMD x86-64 Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

2 cpu on one chip.



 
 
Thread Tools Display Modes
  #1  
Old May 18th 04, 05:01 PM
the gnome
external usenet poster
 
Posts: n/a
Default 2 cpu on one chip.

I keep seeing reports that AMD are going to do a 2 on 1 chip but am confused
as to the number of pins.

Will this chip replaced the AMD 64 chip, with 900 and something pins, or
will they be an upgrade route for an opteron.

Anyone know ?

the_gnome


  #2  
Old May 18th 04, 08:42 PM
rstlne
external usenet poster
 
Posts: n/a
Default


"the gnome" wrote in message
...
I keep seeing reports that AMD are going to do a 2 on 1 chip but am

confused
as to the number of pins.

Will this chip replaced the AMD 64 chip, with 900 and something pins, or
will they be an upgrade route for an opteron.

Anyone know ?

the_gnome



Same pins as my understanding of it goes.


  #3  
Old May 18th 04, 08:44 PM
Tone-EQ
external usenet poster
 
Posts: n/a
Default

I keep seeing reports that AMD are going to do a 2 on 1 chip but am
confused
as to the number of pins.

Will this chip replaced the AMD 64 chip, with 900 and something pins, or
will they be an upgrade route for an opteron.

Anyone know ?


Advanced Micro Devices Inc. will release dual-core Opteron processors for
servers and workstations in 2005, the same time frame that Intel Corp. plans
for its first dual-core products, an AMD executive said Monday.

http://www.infoworld.com/article/04/...ualcore_1.html

Seems to me that they will use the same socket as the current range of
Opteron socket 940 or socket 939, whichever is more suitable at the time.
--
Regards,
Tony. (tony.cue(at)tiscali.co.uk)

Discogs: building the definitive database of electronic music...
http://www.discogs.com

Asus A7N8X-E Deluxe (Revision 1.01, BIOS 1008)
AMD AthlonXP 3200+ (Barton, 11 x 200, 1.65VCore)


  #4  
Old May 19th 04, 05:36 AM
the gnome
external usenet poster
 
Posts: n/a
Default

Seems to me that they will use the same socket as the current range of
Opteron socket 940 or socket 939, whichever is more suitable at the time.



That makes it a bit difficult to purchase a mobo and opterons now, unless
you can just clip off the excess pin at a later date

the_gnome


  #5  
Old May 19th 04, 09:19 PM
General Schvantzkoph
external usenet poster
 
Posts: n/a
Default

On Wed, 19 May 2004 05:36:34 +0100, the gnome wrote:

Seems to me that they will use the same socket as the current range of
Opteron socket 940 or socket 939, whichever is more suitable at the time.



That makes it a bit difficult to purchase a mobo and opterons now, unless
you can just clip off the excess pin at a later date

the_gnome


The are definitely doing it for the Opteron (940 pin) they haven't decided
if they are going to do it for the consumer part (939 pin). My guess is
that they will but it might not happen until a couple of quarters after
the server parts come out. If you really want a dual core upgrade path
then buy an Opteron board now. Personally I wouldn't worry about future
compatibility, you can always buy a new motherboard when the time comes.
Chances are when the dual core parts come out they'll support DDRII RAM so
you'll want to upgrade your RAM also. There will also be SATA drives that
support command queueing so you'll want a new drive to go with the new CPU
and RAM. You see where I'm going with this, in two years there will be
enough improvements in the other components of your system that you'll
want a whole new box anyway.
  #6  
Old May 22nd 04, 12:54 PM
Post Replies Here Please
external usenet poster
 
Posts: n/a
Default

"General" == General Schvantzkoph writes:

General On Wed, 19 May 2004 05:36:34 +0100, the gnome wrote:
Seems to me that they will use the same socket as the current
range of Opteron socket 940 or socket 939, whichever is more
suitable at the time.



That makes it a bit difficult to purchase a mobo and opterons now,
unless you can just clip off the excess pin at a later date

the_gnome


General The are definitely doing it for the Opteron (940 pin) they
General haven't decided if they are going to do it for the consumer
General part (939 pin). My guess is that they will but it might not
General happen until a couple of quarters after the server parts
General come out. If you really want a dual core upgrade path then
General buy an Opteron board now. Personally I wouldn't worry about
General future compatibility, you can always buy a new motherboard
General when the time comes. Chances are when the dual core parts
General come out they'll support DDRII RAM so you'll want to upgrade
General your RAM also. There will also be SATA drives that support
General command queueing so you'll want a new drive to go with the
General new CPU and RAM. You see where I'm going with this, in two
General years there will be enough improvements in the other
General components of your system that you'll want a whole new box
General anyway.

True in most cases after 1-2 years one has to upgrade motherboard and
cpu for many different reasons. Memory is another big reason. I would
suspect these new motherboards in 2 years will have a different memory
setup.

Does any of the current sata drives or controllers support command queueing?

Wondering? The last time I looked at sata drives they were the same as
ide drives.

Later

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Max Chip in a Jetway 663AS Motherboard Eska007 Overclocking AMD Processors 0 November 1st 04 11:26 PM
3.4 or 3.6 Intel 775 Chip ? andyw General 3 September 17th 04 02:47 PM
P2 chip and fan Rich General 8 September 7th 04 08:15 PM
How to identify my graphics chip? edek General 3 February 16th 04 08:08 AM
NIC BIOS chip programming €®ik General 5 October 22nd 03 09:17 AM


All times are GMT +1. The time now is 01:21 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.