If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can I avoid Ripping multiple times using PCL macros
Hi,
I would like to run PCL compatible printers at full speed. Sending down forms with graphics can slow it down. If I store a form as a macro in RAM, will it have to RIP for each page? Is there another technique that I can use with PCL on Windows to avoid multiple RIPs. Thanks Murray |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GI.biz reports their own findings on Revolution: 2.5 times more powerful than Gamecube | [email protected] | Ati Videocards | 1 | December 7th 05 11:02 PM |
Stuff about LA times in the blogs today - I saw this at the website a vague thing about D.GEFFEN possibly buying into the paper | [email protected] | General | 1 | September 18th 05 07:13 PM |
OCR scanning multiple page to one Word or PDF document | MarkB | Scanners | 1 | July 15th 04 11:23 PM |
Windows XP Finding Z53 Multiple Times to Install - help! | Frank Van De Warker | Printers | 0 | November 20th 03 06:34 PM |