If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
can't print - suggestions pls
Having a dinosaur canon BJC600 and haven't used it in 18mths (was
overseas at the time), the NEW ink cart will not print on standard paper now. How could i get this ink to come-out so to speak? Yes there is black ink in the cart but no colour (only want to print in black and have done it before). I have already reset the printer (plug power in and hold down power button simul'). Some help kindly asking? |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
Hi.
This is a new ink cartridge therefore it has ink in it. Brand new. I did an ink cart syst clean three times on the black but no results to print. usually that gets the ink running, not this time. Another suggestion perhaps? Thank you. beezer wrote in message . .. On 18 May 2004 09:21:18 -0700, (jas) wrote: Having a dinosaur canon BJC600 and haven't used it in 18mths (was overseas at the time), the NEW ink cart will not print on standard paper now. How could i get this ink to come-out so to speak? Yes there is black ink in the cart but no colour (only want to print in black and have done it before). I have already reset the printer (plug power in and hold down power button simul'). Some help kindly asking? is this the same NEW cartridge that was in the printer 18 months ago? If so, your nozzels are clogged then. |
#4
|
|||
|
|||
|
#5
|
|||
|
|||
Your printer may have a basic Canon print stop problem. Canon BJC-6000
and other printers have an undocumented "Waste Ink Tank Reset" situation that is programmed into their EEPROMS. The "Waste Ink Tank" is not a tank, but is a blotter-like absorbant pad under the printer mechanism. The printers shut down after a certain number of start-up and Clean cycles and require a procedure to reset the EEPROM. Normally only Canon service centers would perform this built-in falure procedure. You may want to read about this at: http://www.fixyourownprinter.com/printer/11/10445.html |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
4x6 printers | Kenneth Oakman | Printers | 8 | February 29th 04 10:37 PM |
Print more photos on one paper and save printing papers! | Steve Chambers | Printers | 1 | February 26th 04 07:20 PM |
HP Print server - Epson Dot Matrix Printer | UnixUser | Printers | 1 | February 18th 04 09:42 PM |
Non print problem | Wsimon9 | Ati Videocards | 1 | February 10th 04 03:42 AM |
Canon S820 print quality | Dru | Printers | 2 | September 26th 03 03:21 PM |