|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 15th 04, 11:26 AM
|
|||
|
|||
CLI.EXE and WinXP
Hi,
a next question comes up: After the installation fails for Win98 (see a previous posting of me) I tried to install the latest Catalyst for WinXP under WinXP (SP2) of course. When trying to execute the Catalyst Control Center I get an error from CLI.exe. CCC needs the .Net framework - I know - however I first thought SP2 of WinXP will install this automatically, or am I wrong? -- cu, Michael 
|
|
#2
October 16th 04, 01:01 AM
|
|||
|
|||
|
Yes you're wrong.........its a seperate download and the site is listed on the
ATI download page. peter "Michael Fritz" wrote in message ... Hi, a next question comes up: After the installation fails for Win98 (see a previous posting of me) I tried to install the latest Catalyst for WinXP under WinXP (SP2) of course. When trying to execute the Catalyst Control Center I get an error from CLI.exe. CCC needs the .Net framework - I know - however I first thought SP2 of WinXP will install this automatically, or am I wrong? -- cu, Michael
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WinXP always re-detecting video card (9800PRo) | Craig Matchan | Ati Videocards | 8 | July 12th 04 10:33 AM |
| WinXP Install Problem? | BobK | General | 3 | June 2nd 04 10:10 PM |
| Serial ATA drivers for fresh install of WinXP??? | Alceryes | General | 1 | December 26th 03 10:21 PM |
| Problems with WinXP and 2500+ Barton frequency | Mitchua | Homebuilt PC's | 3 | October 26th 03 07:33 PM |
| Completely Copying the WinXP Partition After Clean Install... | Will Mercer | Homebuilt PC's | 7 | September 15th 03 08:19 PM |
Linear Mode
