If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CUSL2 won't boot- blinking power LED
My CUSL2 MB sometimes won't boot. It starts to power up, then within perhaps
0.5 to 1 sec it goes to standby (blinking power LED). When I do get it to boot afterward, it sometimes goes directly to BIOS setup and says it couldn't read the CPU speed (933 MHz) correctly. This seems to be dependent on power supply load. If I disconnect some drives it happens less. The PS is 300W. I believe the total load on the PS is well within 300W. Any ideas? Thanks in advance, Frank Kerfoot |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advice Please: Changing Boot Drive By Disconnecting Power Plug | [email protected] | General | 68 | January 30th 05 02:48 AM |
basic power problem | BrianBloodaxe | General | 19 | July 26th 04 08:48 PM |
NF7-S power up problem | Jeff Green | Abit Motherboards | 9 | January 18th 04 07:06 PM |
Happy Birthday America | SST | Overclocking | 333 | November 27th 03 07:54 PM |
how to give energy to USB devices? with notebook off!!! | andrea rossi | General | 10 | September 12th 03 08:54 PM |