If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
QMS 860 print system :: No lights in controlpanel.
I've just bought an old QMS-860 Print System. When I turn on power, only the
LED for the selected paper-tray is on. The display's first line is full off "boxes", the second line is empty. When pressing the "Test Print" button on the back, a nice page with lines is printed. The printer does not respond to any buttons (Online/Offline or any other), and does not respond to printjobs sent to it. Any ideas as to what I could do to make it work ? Mads Kristensen, Denmark |
#2
|
|||
|
|||
This printer has most likely lost it's firmware.
This is a common problem with this type. I can send you the firmware. You need to copy it to the printer via the pc's parallel port 99% of the times this is a permanent sollution, the other 1% have a defective controllerboard. Jeffrey "Mads Kristensen" wrote in message ... I've just bought an old QMS-860 Print System. When I turn on power, only the LED for the selected paper-tray is on. The display's first line is full off "boxes", the second line is empty. When pressing the "Test Print" button on the back, a nice page with lines is printed. The printer does not respond to any buttons (Online/Offline or any other), and does not respond to printjobs sent to it. Any ideas as to what I could do to make it work ? Mads Kristensen, Denmark |
#3
|
|||
|
|||
Hi!
Firmware would be very nice ... I was unable to find it at "qms-minolta"-website ... Is this printer way too old for support? How is the copying done? How do I make the printer aware of the transfer? / Mads Kristensen "FutureChild" wrote in message ... This printer has most likely lost it's firmware. This is a common problem with this type. I can send you the firmware. You need to copy it to the printer via the pc's parallel port 99% of the times this is a permanent sollution, the other 1% have a defective controllerboard. Jeffrey "Mads Kristensen" wrote in message ... I've just bought an old QMS-860 Print System. When I turn on power, only the LED for the selected paper-tray is on. The display's first line is full off "boxes", the second line is empty. When pressing the "Test Print" button on the back, a nice page with lines is printed. The printer does not respond to any buttons (Online/Offline or any other), and does not respond to printjobs sent to it. Any ideas as to what I could do to make it work ? Mads Kristensen, Denmark |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Updrade PC | Guy Smith | General | 22 | August 15th 04 01:57 AM |
Regarding a fix for large system cache in xp | LostSoul | Ati Videocards | 3 | January 8th 04 05:56 PM |
Cooling Questions | Peter Cavan | General | 35 | September 2nd 03 06:42 AM |
Cooling Questions | Peter Cavan | Overclocking | 37 | September 2nd 03 06:42 AM |