|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 28th 06, 02:48 AM
posted to comp.periphs.printers
|
|||
|
|||
is the Transfer Raster Data Command of PCL just send a row of raster data?
i want to make sure does the PCL command
E*b#W[raster data] just send a row of raster? is one transfer raster data command just send one row? thank you 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SATA "II" external HDD enclosures - 150 or 1500 Mbps data transfer | PJ | Storage (alternative) | 11 | July 12th 05 10:07 AM |
| Modem connection speed | Neil Barnwell | General | 58 | July 14th 04 07:18 PM |
| Maximum System Bus Speed | David Maynard | Overclocking | 41 | April 14th 04 10:47 PM |
| help with motherboard choice | S.Boardman | General | 30 | October 20th 03 10:23 PM |
Linear Mode
