|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 6th 04, 12:16 AM
|
|||
|
|||
GA 7N400 Pro2 Northbridge fan / temp
I have suffered from the Northbridge fan not working,
since then I have disables the smartfan bios setting, and set the fan to always on in ET4. So far, everything seems OK. I don't know how long it was like that, fortunately my case has good airflow & low ambient, so I don't think any damage has been done (fingers crossed). Still a little concerned that if it stops again, I might not notice, is there any way that I can monitor the fan state/rpm or even the northbridge temp? TIA Mark 
|
|
#2
January 6th 04, 09:45 AM
|
|||
|
|||
|
sorry for my english
your systemtemp is not over 40 C Northbridge fan not working. Mark Epps wrote: I have suffered from the Northbridge fan not working, since then I have disables the smartfan bios setting, and set the fan to always on in ET4. So far, everything seems OK. I don't know how long it was like that, fortunately my case has good airflow & low ambient, so I don't think any damage has been done (fingers crossed). Still a little concerned that if it stops again, I might not notice, is there any way that I can monitor the fan state/rpm or even the northbridge temp? TIA Mark
|
|
#3
January 7th 04, 07:26 AM
|
|||
|
|||
|
"Black Canel" wrote in message ... sorry for my english your systemtemp is not over 40 C Northbridge fan not working. Mark Epps wrote: I have suffered from the Northbridge fan not working, since then I have disables the smartfan bios setting, and set the fan to always on in ET4. So far, everything seems OK. I don't know how long it was like that, fortunately my case has good airflow & low ambient, so I don't think any damage has been done (fingers crossed). Still a little concerned that if it stops again, I might not notice, is there any way that I can monitor the fan state/rpm or even the northbridge temp? TIA Mark You could just replace the fan with one that works.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error | kony | General | 6 | October 18th 04 05:38 AM |
| A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error | kony | Asus Motherboards | 0 | October 10th 04 06:32 AM |
| Confused over AMD PR rating | Overclocking AMD Processors | 2 | January 28th 04 01:18 AM | |
| Ga-7N400 Pro2 with XP2800 cpu temp? | Chris Polhill | Gigabyte Motherboards | 1 | January 5th 04 01:14 AM |
| GA 7VN400 pro2 with xp2800 cpu temp? | Chris Polhill | Gigabyte Motherboards | 9 | January 4th 04 02:46 AM |
Linear Mode
